Bull Ring USA Tie Down Anchor - 4001

Bull Ring’s are the premium tie-down anchor point for your truck. While the stock anchors points are inside the bed where it’s hard to reach, Bullrings retractable anchor points easily install into the stake pockets on top of your bed rails. Simply pop the stainless steel ring up when you want to use it to secure a load, then hit it down flush when you don’t. Each is made from stainless steel for a 1000 lbs capacity, matches the exact grain and color of Ford & Dodge railcaps, and comes with our "no bull" Lifetime Warranty. Sold as a pair. Bull Ring's stainless steel tie down anchors are an essential truck bed accessory. Our classic Raised model sits just above the railcap. Installation on most models is quick and easy, and requires nothing more than a Phillips head screwdriver. Typical install time - Under a minute. To get the most out of your tie-down anchors, they can be installed in the 6 stake pockets locations of your truck with 1, 2, or 3 pairs available to fit those slots. • Front – 5', 6', 8' Bed • Middle – 8' Bed • Rear – 5', 6', 8' Bed INSTALLATION Installation is quick and easy, and requires nothing more than a Phillips head screwdriver. Remove any pop-out plastic rail cap covers on the truck bed. Remove the two Phillips head screwdrivers from the anchor.  Hold onto the top plastic Bullring Cover, and guide the lower steele plate at an angle into the hole from the side of the bed. Once the lower plate is inside the stake pocket - let the plastic cover fall into place, and pull up on the steele anchor ring. This will suck up and catch the lower plate onto the trucks sheet metal. Hold the steele anchor ring up while you re-insert and tighten both Phillips screws. Typical install time – Under a minute.

Note: Grained Plastic; Boxed Set of 2